Valcourt Beaumont Manual do Proprietário

45335A Printed in Canada 02-09-2014 PREFABRICATED WOOD-BURNING FIREPLACE INSTALLATION AND OPERATION MANUAL Keep this manual for future reference

10CHIMNEY INSTALLATION 1. If possible, install an interior chimney as it will provide better performance. In areas with continuous temperatures belo

11 Figure 7a Figure 7b

1212. When you build a chase enclosure for chimney sections above the roof, the chimney must extend at least 3 ft. (92 cm) above the chase enclosure

13INSTALLATION INSTRUCTION FOR MASONRY APPLICATION The following requirements must be respected: 1. The chimney must be absolutely clear of any soo

14Installation The chimney must be relined with a stainless steel liner model Tubinox or Projet SS or any other listed liner or flexible liner to U

15Installation with an 7 in. EXCEL chimney (Figure # 8) Installing your fireplace with a masonry chimney still requires using EXCEL chimney from th

16Figure #8: Excel Chimney Installation Figure #9: Security Chimney Installation

17Figure #10: Straight Chimney Installation Figure #11: Chimney Installation with Elbows Figure #12: Chimney Installation through an Exterior Wal

18FIREPLACE FINISH 1. Combustible materials can be used to finish the fireplace. The framing can be built directly on the sides of the appliance. (F

19Figure #15: Chimney Enclosure

2TABLE OF CONTENTS INTRODUCTION...

20Figure #16a : Mantel Positioning

21Figure 16b : Combustible material positioning A : 48 in. B : Radius of 84 in. C : 84 in. Min.

22Figure #17: Installation of Fireplace Facing

23USE AND SAFETY 1. Teach children fireplace safety rules. 2. Do not use the fireplace under the following conditions: 2.1 Whenever a firestone is

24CREOSOTE When wood burns slowly, it produces tar and other organic vapors which combines with humidity to produce creosote. Creosote vapor conden

25REPLACING GLASS Do not use the fireplace with a cracked glass. 1. Cut the silicone joint holding the broken glass to the frame. 2. Remove all deb

26TROUBLESHOOTING Expansion and contraction noises during the heating and cooling cycle are normal. Here is how to prevent smoke flow reversal: pos

27HEAT DISTRIBUTION SYSTEMS Figure #19: Heat Distribution Options GRAVITY DISTRIBUTION KIT The Gravity Distribution Kit (FP4-300) may be used to h

28Installing the Gravity Air Duct System 1. Remove the 7” (178 mm) knockouts in the top of the appliance. Cut the insulating wool and remove the inn

29ATTENTION: The connection to an existing duct must follow the direction of the furnace’s airflow and be equipped with a back draft damper. (Figure

3INTRODUCTION This manual contains all the information required for safe, efficient installation and use of your Valcourt fireplace. Read carefully

30HEAT DISTRIBUTION SYSTEMS

31

32VIEWS WITH MEASUREMENTS FP2D06

33 FP2D06

34 FP2S06

35 FP2S06

36VALCOURT LIMITED LIFETIME WARRANTY The warranty of the manufacturer extends only to the original consumer purchaser and is not transferable. This

4INSTALLATION Beaumont and Frontenac fireplaces are designed and approved for installation with the following brands of chimneys measuring 7” (178

5 Choose the best location for your fireplace based on the position of the doors and windows. Provide for the positioning of the outside air inlet a

6Figure #2: Various Fireplace Locations Figure #3: Possible Chimney Configurations Figure #4: Fireplace Framing

7FIREPLACE INSTALLATION The table below shows the minimum chimney height requirements, fireplace included, according to the number of elbows: Chim

89. The standards in your area may require an outside air inlet. Even if such is not the case, it is beneficial to do so since this will improve the

9 You can also install a decorative gas appliance in the hearth. To do this, install an automatic shut-off valve. Comply with ANSI Z21.60 (1991) sta